SteelHead Interceptor Commands

Configuration Mode Commands : SteelHead Interceptor Commands

This chapter describes commands you use to configure SteelHead Interceptor features. It includes the following sections:

• Interceptor System Commands

• Interceptor Failover Support Commands

• Interceptor Operating Mode Commands

• Load-Balancing Commands

• Interceptor Peering and Redirect Commands

• Load-Balancing In-Path Pass-Through Rules Commands

• Path Selection Support Commands

• VLAN Segregation Commands

• Instance Configuration Mode Commands

• Displaying Interceptor Information

Note: Riverbed recommends that you use the Interceptor Management Console to configure the SteelHead Interceptor. For details, see the SteelHead Interceptor User’s Guide and the SteelHead Interceptor Deployment Guide.

Note: You must also set up the host and networking configuration, configure in-path interfaces, and configure in-path rules for deployments that use the SteelHead Interceptor for load balancing. These commands are common to the SteelHead and SteelHead Interceptor. For detailed information, see the previous sections of this chapter.

Interceptor System Commands

This section describes the Interceptor system commands.

Note: For hardware-assist rule commands, see Hardware-Assist Rule Commands.