Configuration Mode Commands : SteelHead Interceptor Commands : VLAN Segregation Commands : instance
  
instance
Enters instance configuration mode for the specified instance. An instance represents a logical Interceptor. You create instances so that you can optimize traffic independently from other instances and provide VLAN segregation.
Syntax
instance <instance-name>
Parameters
<instance-name>
Name of the VLAN instance.
Usage
After entering instance configuration mode you can:
•  enable or restart an instance.
•  configure in-path rules.
•  configure load-balancing rules.
•  manage Steelhead appliances (for example, adding and removing).
•  add and remove VLANs.
The following commands are available for configuring instances:
•  failover interceptor - For details, see failover steelhead interceptor name.
•  in-path passthrough {move-rule | rule} - For details, see in-path passthrough move-rule, in-path passthrough rule allow, in-path passthrough rule block, and in-path passthrough rule edit.
•  in-path move-rule - For details, see in-path move-rule
•  interceptor {communication allow-failure | name} - For details, see interceptor communication allow-failure enable, interceptor communication interface, and interceptor communication multi-interface enable.
•  load balance {default-rule | fair-peer-v2 | move-rule | rule} - For details, see load balance default-rule fair-peering, load balance fair-peer-v2 enable, load balance move-rule, load balance rule edit rulenum, load balance rule pass, and load balance rule redirect.
•  show - For details, see show detail show failover interceptor, show in-path interfaces, show in-path passthrough rules, show load balance fair-peer-v2, show load balance rules, show steelhead communication, and show steelhead name all.
•  steelhead communication - For details, see steelhead communication ack-timer-intvl, steelhead communication interface, steelhead communication multi-interface enable, steelhead communication read-timeout, and steelhead communication recon-timeout.
•  steelhead name - For details, see steelhead name (Interceptor), and steelhead pressure-mon enable.
•  vlan <id> add - For details, see vlan add.
Example
amnesiac (config)# instance foo
(instance-config)#
Product
Interceptor
Related Commands
instance-config create, show detail, vlan add, vlan-seg enable
Instance Configuration Mode Commands
This section is a reference for Interceptor instance configuration mode commands.
To enter instance configuration mode, use the instance command. To exit instance configuration mode, enter exit.