This chapter is a reference for configuration mode commands. It includes the following sections:

You can perform configuration tasks while in configuration mode. Only administrator users can perform configuration mode and enable mode commands. All commands available in user mode and enable mode are also available in configuration mode. Monitor users cannot perform configuration tasks.

You are now in configuration mode.

To exit configuration mode, enter exit. For information about the exit command, see exit.

Although most of the SteelHead configuration commands are also available in the SteelHead Interceptor, Controller, SteelCentral Controller for SteelHead Mobile, and SteelHead (in the cloud), Riverbed strongly recommends that you do not use the CLI to perform configuration tasks on these products. Riverbed recommends that you use these products respective Management Consoles to perform configuration, system administration, and system reporting and monitoring tasks.

For an alphabetical list of commands, see the index at the end of this document.