Configuration Mode Commands : SteelHead Interceptor Commands : Interceptor Operating Mode Commands : appliance operating-mode 9350
  
appliance operating-mode 9350
Changes the operating mode of the 9600 appliance to one compatible with the 9350 appliance.
Syntax
[no] appliance operating-mode 9350
Parameters
None
Usage
This command is intended for use in topologies with a mixture of appliances (for example, both the 9600 appliance and the 9350 appliance).
The no command option returns the 9600 appliance to the original operating mode.
Note: For the no command option, the 9350 keyword is not applicable and is not included in the command syntax.
Note: This command is supported only on the 9600 appliance.
After using this command, you must restart the service for the change to take effect.
Example
amnesiac (config) # appliance operating-mode 9350
amnesiac (config) # no appliance operating-mode
Product
Interceptor
Related Commands
show appliance operating-mode
Load-Balancing Commands
This section describes the load-balancing commands.