Configuration Mode Commands : SteelHead Configuration Commands : Management In-Path Interface Commands : in-path interface mgmt-interface vlan
  
in-path interface mgmt-interface vlan
Specifies the VLAN ID for the management in-path (MIP) interface.
Syntax
[no] in-path interface <interface> mgmt-interface vlan <vlan>
Parameters
<interface>
MIP interface; for example, inpath0_0.
<vlan>
VLAN tag ID.
When you specify the VLAN tag ID for the MIP interface, all packets originating from the SteelHead are tagged with that identification number. Specify the VLAN tag that the appliance uses to communicate with other SteelHeads in your network. The VLAN Tag ID might be the same value or a different value than the in-path interface VLAN tag ID. The MIP interface could be un-tagged and in-path interface could be tagged and vice versa. A zero (0) value specifies non-tagged (or native VLAN) and is the correct setting if there are no VLANs present.
For example, if the MIP interface is 192.168.1.1 in VLAN 200, you would specify tag 200.
Usage
For details, see the Management Console online help or the SteelHead Management Console User’s Guide.
The no command option resets the MIP VLAN.
Note: This command requires you to also configure in-path interface vlan and in-path interface mgmt-interface ip.
Example
amnesiac (config) # in-path interface inpath0_0 mgmt-interface vlan 26
Product
SteelHead CX, SteelHead EX, SteelHead-v, SteelHead-c
Related Commands
in-path interface mgmt-interface ip, , show in-path mgmt-interface, in-path interface vlan
WAN Visibility (Transparency) Commands
This section describes WAN Visibility commands.
For details about WAN Visibility and configuring WAN transparency, see the SteelHead Deployment Guide.