steelhead interceptor communication interface
Sets the interface to use for Interceptor-to-SteelHead communication.
Syntax
steelhead interceptor communication interface <interface-name>
Parameters
<interface-name> | Interface name. |
Usage
This command replaces the in-path neighbor interface command.
Caution: Make sure you configure the SteelHead to communicate with this SteelHead Interceptor on this interface when you configure SteelHead-to-Interceptor communication.
Assume you want to configure peering between Interceptor A (with primary interface 10.10.10.1, inpath0_0 interface 10.10.10.2, inpath0_1 interface 10.10.10.3) and SteelHead Z (with primary interface 10.10.10.21, inpath0_0 10.10.10.22, inpath0_1 interface 10.10.10.23).
1. Log in to the CLI for Interceptor A.
2. Specify which in-path interface on Interceptor A to use for Interceptor-to-SteelHead peering:
steelhead interceptor communication interface inpath0_0
3. Add SteelHead Z as a peer by specifying the name and IP address for the SteelHead Z inpath0_0 interface:
steelhead interceptor name shaZ main-ip 10.10.10.22
4. Log in to the CLI for SteelHead Z.
5. Enable the in-path interface:
in-path enable
6. Enable the out-of-path support:
in-path oop enable
7. Enable peering:
in-path neighbor enable
8. Specify the neighbor name and main IP address:
in-path neighbor name interceptA main-ip 10.10.10.2
The no command option disables the interface.
Note: Disable multiple interface support for the SteelHead Interceptor before changing the communication interface. To disable multiple interface support, use the no steelhead interceptor communication multi-interface command.
Example
amnesiac (config) # steelhead interceptor communication interface inpath0_0
Product
SteelHead Interceptor
Related Commands