SD-WAN Management Nodes
Alluvio Flow Gateway receives SD-WAN information from NetFlow and sends it to NetProfiler. Flow Gateway needs to be configured as the NetFlow export destination for the Cflowd policy of the vManage node. The SD-WAN Management Nodes page in NetProfiler lets you view and monitor the status of the SD-WAN management nodes. From here you can also add new management nodes or edit, delete, or disable existing management nodes.
Configuration information is polled automatically every 24 hours and the lastest polling time is listed in the table. Interface groups are automatically created based on the SD-WAN site and overlay definitions.
Performance statistics are polled at 10-minute intervals.
Note: NetProfiler must have REST API access to vManage nodes.
Receiving SD-WAN information from Alluvio Flow Gateway
- Flow Gateway needs to be configured as the NetFlow export destination for the Cflowd policy of the vManage node
- "Loopback" must be as the value for "Source Interface" parameter
- Include VPN 0 and 512
Adding vManage Nodes on the NetProfiler
To configure polling of the vManage node NetProfiler, do the following:
- In the SD-WAN Management Nodes page (Administration > Integration > SD-WAN), click Add.
- Specify the IP address and login credentials for the vManage node.
- Select Enabled, to enable polling for this node.
- Click OK.