Configuring Core for jumbo frames
If your network infrastructure supports jumbo frames, configure the connection between the Core and the storage system as described in this section. Depending on how you configure Core, you might configure the primary interface or one or more data interfaces.
In addition to configuring Core for jumbo frames, you must configure the storage system and any switches, routers, or other network devices between Core and the storage system.
1. In the Core Management Console, choose Configure > Networking and open the relevant page (Management Interfaces or Data Interfaces) for the interface used by the Core to connect to the storage network. For example, eth0_0.
2. On the interface on which you want to enable jumbo frames: enable the interface, enter the IPv4 address, and then specify 9000 bytes for the MTU setting.
3. Apply, and then save your changes.