Editing Protocol Filters
1. Go to Administration > General Traffic Settings: Traffic Analysis Filters, and click the tab for the set of protocols you want to work with.
2. With your mouse, hover over the application filter to be edited. Click the pencil icon that appears at the end of the row.
3. The Edit Traffic Filters dialog opens, showing the current filter definitions by protocol.
– To delete an IP protocol, hover over the entry and click the x that appears at the end of the entry.
– To revise an existing IP protocol entry, hover over the protocol and click the pencil icon on the right.
4. In the Edit Traffic Filters dialog, the existing IP protocol, server ports, and server IP addresses are displayed.
– To change the existing IP protocol, select the new IP protocol from the drop-down list.
– To delete a port or port range, click in the Server Ports box and click the x to the right of the entry.
– To edit existing Server Ports, click in the Server Ports box and enter your changes. Existing ports can be edited by double-clicking in their box. New ports can be added one at a time or in a comma-separated list. Port ranges can be entered separated by a dash. A mix of ports and port ranges can be entered in a comma-separated list. Press the Enter key after each entry.
– To add a Server IP address, click in the Server IP box and enter an address or a range of addresses, separated by commas. IPv4 and IPv6 addresses in standard or CIDR format can be used.
5. Click Apply to make the changes or Revert to discard them.
6. In the Edit Traffic Filters dialog, click Save to update the filter.