Control | Description |
Connect to a SteelFusion Core | Enables SteelFusion Core settings. |
Hostname/IP | Specify the hostname of the SteelFusion Core. Important: The SteelFusion Core identifier is case-sensitive. |
SteelFusion Edge Identifier | Specify a value by that the current appliance device can be recognized by the SteelFusion Core. You may use any value. For example, the hostname of the device. Note: The SteelHead EX must be licensed. Important: If failover is configured, both appliances must use the same self-identifier. In this case, you can use a value that represents the group of appliances. For detailed information, see the SteelHead Management Console User’s Guide for SteelHead EX. |
Port | Specify the port number for the SteelFusion Core. The default value is 7970. |
Local interface | Select the local interface from the drop-down list. The default value is primary. |
Connect to an active SteelFusion Edge as Standby Peer for High Availability | Enables SteelFusion Edge settings. High Availability speeds up pass-through traffic handling. |
SteelFusion Edge Serial Number | Specify the SteelFusion Edge serial number. |
SteelFusion Edge Identifier | Specify a value by that the current appliance device can be recognized by the SteelFusion Edge. |
SteelFusion Edge IP Address | Specify the SteelFusion Edge IP address. A legal IPv4 address (nnn.nnn.nnn.nnn) is required. |
Interface | Select the interface from the drop-down list. The default value is primary. |
Alternate SteelFusion Edge IP Address | Specify the SteelFusion Edge IP address. A legal IPv4 address (nnn.nnn.nnn.nnn) is required. |
Alternate Interface | Select an alternate interface from the drop-down list. The default value is primary. |
Interface to SteelFusion Core | Select the interface to SteelFusion Core from the drop-down list. The default value is primary. |
Apply | Click Apply to complete the SteelFusion Core configuration. |