This topic describes how to configure QoS shaping on SteelHead SD 2.0. It includes these sections:

These procedures describe QoS shaping for SteelHead SD 570-SD, 770-SD, 3070-SD appliances and the SteelConnect SDI-2030 gateway located at the branch.

SteelHead SD 2.0 supports QoS shaping to allocate bandwidth and prioritize traffic. With SteelHead SD QoS there are no classes to configure: you simply set the bandwidth with a fixed value to provide QoS shaping on inbound and outbound traffic. QoS shaping is supported on site uplinks of a given WAN.

You configure QoS as a policy on a WAN uplink to ensure that your uplink doesn’t exceed a set bandwidth. For example, if you know your uplink can’t handle more than 100 Mbps, you set your limit at something lower than 100 Mbps to ensure that you have a minimal level of service for that uplink. If traffic exceeds the configured bandwidth, it is buffered and shaped. If traffic exceeds the buffer capacity, it is dropped. The QoS shaper throttles and limits traffic to your configured bandwidth.

QoS prioritizes traffic flowing on:

SteelHead SD QoS uses a class-based queuing implementation that assigns packets with a DSCP mark to one of the four dedicated service class queues and distributes bandwidth between them using a deficit weighted round robin (DWRR) scheme. Traffic scheduling and shaping uses a basic single rate and bucket algorithm to regulate the data transmission rate and drain the queues. QoS shaping:

If all queues have equal size packets, and all queues are full, they are not handled equally. Urgent receives 40% of the bandwidth, High receives 30%, Normal receives 20%, and Low receives 10%. This bandwidth distribution occurs when you have different traffic classes shared on the same WAN uplink and under congestion conditions they are competing for the same bandwidth rate. If all your traffic is in the Low traffic class, then it’s not competing with the other queue classes, so it receives 100% of the bandwidth.

Traffic scheduling and shaping uses a basic single rate to regulate the data transmission rate and drain the queues. Each round turn traverses only traffic class queues that are in the active bitmap and always in the order from higher to lower priority queues. The token bucket shaper then throttles the rate at which packets are transmitted by determining when a packet selected by the DWRR can be sent.

To ensure that each class-based queue doesn’t overflow, when the queue is filled to its maximum capacity, the newly arriving packets are dropped until the queue has enough room to accept incoming traffic.

To view the TOS/DSCP and QoS traffic classes table, see TOS, DSCP, QoS Traffic Class Table

You can also configure custom DSCP marks in the SCM when you configure the QoS priority in traffic rules (Rules > Traffic Rules > New Traffic Rule). Traffic rules allow you to mark traffic to specific DSCP value. Only DSCP marked traffic is placed in the QoS priority queues. Traffic must have a DSCP marking value for QoS traffic to be classified. For details, see Directing traffic using traffic rules in the SteelConnect Manager User Guide.

If the QoS priority is configured in a traffic rule, then:

Setting the QoS priority in the traffic rule marks the traffic with the configured DSCP value upon egress, which executes independently of QoS shaping.

For example, if the original DSCP mark on the traffic is NORMAL priority and matches the traffic rule with the QoS priority set to URGENT, then QoS shaping will be influenced as follows: