storage coredr witness set
Sets up the witness Edge for disaster recovery. The witness monitors the state of both the primary and secondary Cores. If both Cores are in a state where failover is not possible (due to failed configuration synchronization, etc.), the witness will report that failover is not ready and will not succeed.
Syntax
storage coredr witness set <edge-id>
Parameters
<edge-id> | IP address for the Edge that will serve as the witness. |
Usage
After you have peered the Cores together using the
storage coredr setup peer command, you will use
storage coredr witness set (this command) to set up the witness.
Example
amnesiac (config) # storage coredr witness set Edge01NYC
Product
Core