Clears the existing data center replication setup. This command is only available from the primary data center, and only permitted if the secondary data center is connected. When high-availability is configured, this command is only permitted on the primary data center leader.

None

This command is part of a workflow for terminating disaster recovery on the Core:

1. Use the storage coredr lun remove-replica command to unmap each replica LUN from the secondary data center before proceeding.

2. Use the storage coredr clear command.

3. Use the storage coredr edge command to stop replication on the Edges.

4. Use the storage coredr interface command to verify that replication is stopped. If "Peer Site ID" is shown as "Not Configured,” you have stopped replication successfully.

5. Use the storage coredr clear-params command to completely remove disaster recovery settings.

Core