1

USB port

 

2

NMI Button

Puts the appliance in a halt state and issues a non-maskable interrupt (NMI). This helps when performing diagnostics for a given issue where a memory download is necessary to determine the cause of the problem. To prevent an inadvertent system halt, the NMI button is located behind the front Control Panel faceplate and is only accessible with the use of a small tipped tool such as a pin or paper clip.

3

Primary Network Interface Card (NIC) activity LED

Solid green = Network link is detected.
Blinks green = Activity. The blink rate is consistent with the amount of network activity.

4

System Cold Reset Button

Reboots the appliance.

5

Hardware Status LED

Off = System is powered off.

Solid green = Hardware is working correctly.

Blinks green= System hardware is degraded.

The system is operating in a degraded state although still functional, or system is operating in a redundant state but with an impending failure warning.

Blinks amber = The system is operating in a degraded state with an impending failure warning.

Solid amber = The system has failed or shutdown.

6

Power Button with Integrated LED

Green = System on
No light = System off

7

Drive Activity

Blinks green = Activity

8

Auxiliary NIC activity LED

Solid green = Network link is detected.
Blinks green = Activity. The blink rate is consistent with the amount of network activity.

9

System ID Button with Integrated LED

Toggles the integrated ID LED and the blue server board ID LED on and off. The System ID LED identifies the system for maintenance when installed in a rack of similar server systems. You can also remotely turn on and turn off the System ID LED using the IPMI “Chassis Identify” command which causes the LED to blink for 15 seconds.

LEDs on Disk Drives

Activity LED
Blinks green = Read/write activity

Disk Fault LED
Orange = Failed disk
Blinks Orange = RAID rebuild

Primary and AUX Ports

Left LED
Solid green = Network link is detected.
Blinks green = Activity

Right LED
No light (with link on left LED) = 10 Mbps data rate
Green = 100 Mbps data rate
Yellow = 1000 Mbps data rate

LEDs on Power Supply

Solid green = Power on and healthy
No AC power = Off
Blinks green = Standby or power supply firmware updating
Amber = Power lost but second power supply has power
Blinks amber = Power on with warning events (high temperature, high power, high current, slow fan)

Form factor

2U

Hard disk/SSD

10 Hot swappable drives

Data store

9.6 TB

Packaged dimensions (LxWxH)

37 x 24 x 11 in.

939.8 x 609.6 x 279.4 mm

Weight (without packaging)

46 lb, 20.87 kg

Voltage frequency

100-127 V, 200-240 V

PSU

2 x 1100 W

100-127 VAC/10 A, 50/60 Hz

200-240 VAC/6 A, 50/60 Hz

PCI slots

6

Maximum number of ports

8

PSU type

2 x 1100 W

AC input

230 V

Max. amps.

2.7

Max. watts

546

Typical watts

437

Max VA

575

Power factor

99.16

BTU (typical)

1490

Operating acoustic

70 Decibels

Temperature (Operating)

10° to 35°C (50° to 95°F)

Temperature (Storage)

-40° to 70°C (-40° to 158°F)

Relative humidity (operating)

20% to 80%, noncondensing with a maximum wet bulb of 28°C (at temperatures from 25° to 35°C)

Relative humidity (storage)

50% to 90%, noncondensing with a maximum wet bulb of 28°C (at temperatures from 25° to 35°C)