nettest run ip-port-reach
Runs the IP address and port test.
Syntax
nettest run ip-port-reach source <interface> {addr <ipv4-address> |ipv6-addr <ipv6-address>} [port <port>]
Parameters
source <interface> | Specifies the source interface. |
addr <ipv4-address> | Specifies the peer IPv4 address to check. |
ipv6-addr <ipv6-address> | Specifies the peer IPv6 address to check. |
port <port> | Specifies the port to check. |
Usage
Use this command to determine whether a specified IP address and optional port is correctly connected. If you specify only an IP address, the test sends an ICMP message to the IP address. If you specify a port number, the test telnets to the port.
If the test fails, ensure that dynamic or static routing on your network is correctly configured and that the remote network is reachable from hosts on the same local subnet as this appliance.
Example
amnesiac (config) # nettest run ip-port-reach source addr 10.0.0.1
Product
SteelHead CX, SteelHead EX, SteelHead-v, SteelHead-c
Related Commands