protocol snapmirror filer
Configures SnapMirror settings for a filer.
Syntax
[no] protocol snapmirror filer <name> [optimization <policy>] [priority <policy>] [description <description>]
Parameters
<name> | Name of the filer. |
optimization <policy> | Specifies an optimization policy for the filer: • sdr-default - Enables SDR and LZ compression. The default value is sdr-default. • lz-only - Enable LZ compression only. There is no SDR optimization with this setting. • none - Disables SDR and LZ compression. |
priority <policy> | Specifies the priority policy for the filer: • highest - Highest priority • high - High priority • medium - Medium priority • low - Low priority • lowest - Lowest priority • none - Priority not set |
description <description> | Specifies a filer description or provides additional comments. |
Usage
A filer is a NetApp storage device. Use this command to prioritize replication job priority and optimization policy by filer.
You can configure the optimization level from no compression (none) to full Scalable Data Replication (sdr-default). SDR optimization includes LZ compression on the cold, first-pass of the data. You can also configure LZ-compression alone (lz-only) with no SDR. For some applications, it might be more important to get maximum throughput with minimal latency, and without compression, and for others getting maximum reduction is more important.
The no command option removes the optimization settings for the filer. By default, SnapMirror optimization support is disabled. If you have enabled or disabled SnapMirror optimization or changed a setting, you must restart the optimization service
Example
amnesiac (config) # protocol snapmirror filer ksnap1 address 10.11.100.1
amnesiac (config) # protocol snapmirror filer ksnap1 optimization lz-only priority medium
amnesiac (config) # service restart
Product
SteelHead CX, SteelHead EX, SteelHead-v, SteelHead-c
Related Commands