protocol snapmirror filer address
Creates a new filer identifier with a specified address or modifies an existing filer ID.
Syntax
[no] protocol snapmirror filer <name> address <ipv4-address>
Parameters
<name> | Name of the filer. |
<ipv4-address> | Source IPv4 address to associate with the filer. |
Usage
A filer is a NetApp storage device.
Use this command to create a new filer ID with the specified IP address or you can add an IP address to an existing filer ID. By default, SnapMirror optimization support is disabled. If you have enabled or disabled SnapMirror optimization or changed a setting, you must restart the optimization service.
Example
amnesiac (config) # protocol snapmirror filer CENTRALFILER address 10.32.146.160
amnesiac (config) # service restart
Product
SteelHead CX, SteelHead EX, SteelHead-v, SteelHead-c
Related Commands