protocol citrix auto-msi enable
Enables Citrix autonegotiate multi-stream ICA.
Syntax
[no] protocol citrix auto-msi enable
Parameters
None
Usage
Enable this command on the client-side SteelHead to use four connections for a single Citrix session. By default, the Citrix clients use one TCP connection for a Citrix session (unless the XenApp/Desktop server is configured for multi-stream ICA).
When enabled, the SteelHead identifies the priority of each connection to allow for finer QoS shaping and marking of Citrix traffic. You can use this feature with both inbound and outbound QoS on the server-side and client-side SteelHead. Both SteelHeads must be running RiOS 9.1. You can also use this feature with path selection to select and prioritize four separate TCP connections.
The Citrix deployment must support multi-stream ICA: the clients must be running Citrix Receiver 3.0 or later. The servers must be running XenApp 6.5 or later or XenDesktop 5.5 or later.
This feature is applicable for CGP and ICA connections.
No configuration is required on the server-side SteelHead. This command does not require an optimization service restart.
Example
amnesiac (config) # protocol citrix citrix auto-msi enable
Product
SteelHead CX, SteelHead EX, SteelHead-v, SteelHead-c
Related Commands