authentication policy user login-failures reset

Configuration Mode Commands : System Administration Commands : Account Control Management Commands : authentication policy user login-failures reset

Resets a user account so the user can log in again.

Syntax

[no] authentication policy user <username> login-failures reset

Parameters

User login: admin, monitor, or shark.

Usage

If a user account is locked because of a failed login count exceeding the configured value, the authentication policy user login-failures reset command resets the account so the user can log in again. This command resets the login count to zero, which is the default value.

Example

amnesiac (config) # authentication policy user admin login-failures reset

Product

SCC, Interceptor, Mobile Controller, SteelHead CX, SteelHead EX, SteelHead-v, SteelHead-c

Related Commands

show authentication policy

ACL Management Commands

This section describes the ACL management commands. For details, see the Management Console online help or the SteelHead Management Console User’s Guide.