srcaddr <network> | Specifies an IPv4 address and mask for the traffic source. Use the format XXX.XXX.XXX.XXX/XX. |
dstaddr <network> | Specifies an IPv4 address and mask for the traffic destination. Use the format XXX.XXX.XXX.XXX/XX. |
dstport <port> | Specifies a destination port or port label for this rule. You can specify: • a single port number. • a comma-separated list of ports with or without ranges (for example, 1,2,4-10,12). • any user-defined port labels. Valid port labels include: – SteelFusion – Interactive – RBT-Proto – Secure For details on port labels, see port-label. |
allow-scps | Specifies an SCPS mode for this rule. • enable—Enables a rule to optimize single-ended interception SCPS connections. • disable—Disables a rule to optimize single-ended interception SCPS connections. If you choose this option, single-ended interception SCPS connections pass through the SteelHead unoptimized. |
scps-peer-only | Specifies an SCPS peering rule. • enable—Allows SCPS peering for single-ended interception SCPS connections. • disable—Allows both SCPS and non-SCPS peering (for example, proxy fallback) for single-ended interception connections. |
vlan <tag-id> | Specifies a VLAN tag ID for this rule. • 1 to 4094 • 0 (for untagged) • -1 (for all) |
cong-ctrl-algo <method> | Specifies a method for congestion control for the rule: • default—Standard TCP optimization (RFC compliant). • hstcp—High-speed TCP optimization. • bw-est—TCP bandwidth estimation. • per-conn-tcp—SkipWare per-connection TCP. This is the default algorithm. • err-tol-tcp—SkipWare error-tolerant TCP optimization. |
rate-pacing | Specifies whether to enable or disable rate pacing. • enable—Enables rate pacing. • disable—Disables rate pacing. Rate pacing is disabled by default. Enabling rate pacing evenly spreads the transmission of a window of packets across the entire duration of the round-trip time. |
rulenum <rule-number> | Specifies the number or order in the SCPS rule table for this rule. • 1 to N or start/end |