Reconfiguring Edge
To reconfigure Edge, modify these settings:
Primary Core Hostname/IP
Updates the Core hostname or IP address. Click edit next to Hostname, change the hostname or IP address, and click Update Hostname to confirm.
Local Interfaces
Enables a local interface on the Edge to use for data and management connections. Click Add Interface, select a local interface from the drop-down menu, and click Add Interface to confirm.
Remove Core removes the Core. Click to disconnect the Edge from the Core, and then click Remove Core to confirm.
Clear High Availability Peer
Disconnects the peer from its appliance buddy. (This option appears when a peer is configured for Edge high availability.) On the standby peer, click to remove the HA peer appliance, and then click Clear Peer to confirm. The Management Console displays the Storage Edge Configuration page after removing the peer.
The standby peer must be in either the Standby Rebuild or Standby Sync state before you clear it.
When the system disconnects the standby peer, its configuration is reset and the active peer enters a degraded health state. To clear both peers, repeat this procedure on the active peer.
The active peer must be in the Active Degraded state before you clear it.
When the system disconnects the active peer, it remains connected to the Core and continues servicing LUNs.