Managing SteelHeads : Configuring Scheduled Jobs
  
Configuring Scheduled Jobs
You can view completed, pending, inactive jobs, as well as jobs that were not completed because of an error in the Administration > Maintenance: Scheduled Jobs page. You can also delete a job, change its status, or modify its properties.
Jobs are commands that are scheduled to execute at a time you specify.
You can use the Management Console to:
•  schedule an appliance reboot or shut down.
•  generate multiple TCP trace dumps on a specific date and time.
To schedule all other jobs, you must use the Riverbed CLI.
For details about scheduling jobs using the CLI, see the Riverbed Command-Line Interface Reference Manual.
To configure scheduled jobs
1. Choose Administration > Maintenance: Scheduled Jobs to display the Scheduled Jobs page.
Figure: Scheduled Jobs Page
2. Select Enabled or Disabled from the drop-down list to enable or disable the job.
3. Select the Job ID number to display details about the job.
4. Under Details for Job <#>, complete the configuration as described in this table.
Control
Description
Name
Specify a name for the job.
Comment
Specify a comment.
Interval (seconds)
Specify the number of seconds between job recurrences. Specify 0 to run the job one-time only.
Executes on
Specify the start time and end time using the format YYYY/MM/DD HH:MM:SS.
Enable/Disable Job
Select the check box to enable the job, clear the check box to disable the job.
Apply Changes
Applies the changes to the current configuration.
Cancel/Remove This Job
Cancels and removes the job.
Execute Now
Runs the job.
Remove Selected Jobs
Select the check box next to the name and click Remove Selected Jobs.
5. Click Save to Disk to save your settings permanently.