Using SteelHead-c for VMware ESX/ESXi : Basic steps to deploy a SteelHead-c for ESX/ESXi
  
Basic steps to deploy a SteelHead-c for ESX/ESXi
This table lists the deployment tasks.
Task
Reference
1. Install the SteelHead-c using VMware vSphere.
2. Configure the resources that the ESX server will be granting the SteelHead-c.
3. Complete the initial configuration of the SteelHead-c.
4. Obtain the one-time token from the Riverbed Cloud Portal.
5. Apply the one-time token to the SteelHead-c.
 
6. Use the Riverbed Cloud Portal to monitor the SteelHead-c.
7. If you decide not to use the Discovery Agent, go to Step 9.
 
8. Install and manually configure the Discovery Agent on the server. You cannot use the Riverbed Cloud Portal to configure the Discovery Agent for SteelHead-c. You must use the manual mode.
9. If you are not using the Discovery Agent, configure the client-side SteelHead in-path rules to point to the SteelHead-c for server.
SteelHead Management Console User’s Guide
10. If your network is NATed, go to Step 11.
 
11. If you are not using the Discovery Agent, configure the SteelHead-c for public or private IP address mapping.