Settings to view completed, pending, inactive jobs, as well as jobs that were not completed because of an error are under Administration > Maintenance: Scheduled Jobs. You can also delete a job, change its status, or modify its properties.

Jobs are commands that are scheduled to execute at a time you specify.

You can use the Management Console to:

To schedule all other jobs, you must use the Riverbed CLI.

For details about scheduling jobs using the CLI, see the Riverbed Command-Line Interface Reference Manual.

Select Enabled or Disabled from the drop-down list to enable or disable the job. Select the Job ID number to display details about the job.

Under Details for Job <#>, these configuration options are available:

Name specifies a name for the job.

Comment specifies a comment.

Interval (seconds) specifies the number of seconds between job recurrences. Specify 0 to run the job one-time only.

Executes on specifies the start time and end time using the format YYYY/MM/DD HH:MM:SS.

Enable/Disable Job enables or disables the job. Select the check box to enable the job, clears the check box to disable the job.

Interval (seconds) specifies how often the job runs. The default value is 0, which runs the job once.

Executes On specifies the date on which the job runs.

Enable/Disable Job enables the job to run at the specified date or clear to prevent the job from running.

Apply Changes applies the changes to the current configuration.

Cancel/Remove This Job cancels and removes the job.

Execute Now runs the job.

Remove Selected Jobs removes the job. Select the check box next to the name and click Remove Selected Jobs.