This chapter is a reference for user mode commands.

User mode commands allow you to enter enable mode, display system data, and perform standard networking tasks. Monitor users can enter user mode commands. All commands available in user mode are also available to administrator users.

Connect to the CLI and enter the following:

Many of the CLI commands are applicable to multiple Riverbed products. Most user mode commands available on the Edge and Core are available on SteelHead products.

Many CLI commands that are common across product lines might contain information that is applicable only to the SteelHead.

See the Riverbed Command-Line Interface Reference Manual for information on the common user mode commands that are common across multiple Riverbed products. If you have additional questions about the usage of a command, contact Riverbed Support.

The following commands display information about Core configuration.