storage snapshot storage-array remove host
Removes a snapshot host.
Syntax
[failover-peer] storage snapshot storage-array remove host <hostname>
Parameters
failover-peer | Performs the command on the failover peer of the current appliance. If the failover peer is unavailable, the changed configuration is automatically applied when the appliance returns to service. You can run failover-peer commands only on a Core appliance in ActiveSolo failover state. |
<hostname> | Hostname of the storage array. |
Example
amnesiac (config) # storage snapshot storage-array remove host sf-vva14
Product
Core
Edge commands
This section describes the Edge system commands. You can use the command line to perform basic configuration tasks, display configuration information, and check status. It includes the following information.