edge add id
Adds an Edge to the running Core configuration.
Syntax
[failover-peer] edge add id <id>
Parameters
failover-peer | Performs the command on the failover peer of the current appliance. If the failover peer is unavailable, the changed configuration is automatically applied when the appliance returns to service. |
<id> | Self-identifier of the Edge to which the configuration is to be pushed. This value is case sensitive and limited to the following characters: 0 to 9, a to z, A to Z, period (.), and hyphen (-). |
Usage
Use this command to add an Edge to the current Core configuration. Each Edge is configured with a unique self-identifier (which is configured through the Edge).
All failover-peer edge commands enable you to configure an unavailable Core through its failover peer. When the intended Core becomes operational, the new configuration is added automatically. You can run failover-peer commands only on a Core appliance in ActiveSolo failover state.
Example
Core_01 (config) # edge add id BranchEdge001
Core_02 (config) # failover-peer edge add id Edge3
Product
Core