device-failover peer set (Core)
Sets the failover peer configuration. You configure the local interface parameters in pairs.
Syntax
device-failover peer set <peer-ip> [local-if <local-interface>] additional-ip <additional-ip> [local-if2 <local-interface2>]
Parameters
<peer-ip> | IP address of the failover peer appliance. |
local-if <local-interface> | Specifies the local interface for connecting with the failover peer appliance IP. |
additional-ip <additional-ip> | Specifies an additional IP address for the failover peer appliance. |
local-if2 <local-interface2> | Specifies an additional local interface for connecting with the failover peer appliance IP. |
Usage
Use this command to enable two Cores to be configured so that either one can fail without disrupting the service of any of the LUNs being provided by the product.
Example
Core_02 (config) # device-failover peer set 10.1.1.1 local-if eth0_0 additional-ip 10.2.1.1
Product
Core