User Mode Commands : Displaying System Data : show path-selection channels
  
show path-selection channels
Displays the path-selection channel states.
Syntax
show path-selection channels [site <name>] [uplink <name>]
Parameters
site <name>
Displays the channel information associated with paths to the specified site.
uplink <name>
Displays the channel information associated with paths to the specified uplink.
Example
amnesiac >show path-selection channels uplink MPLS site Bangalore
Channel ID:              5
  Status:                Up
  Interface:             inpath0_0
  Gateway IP:            172.16.113.1
  Neighbor IP:           172.16.113.12
  Active for:
     Local Uplink:       MPLS
     Remote Peer(s):     172.16.110.2, 172.16.112.2
     Remote Site:        Bangalore
 
     Local Uplink:       MPLS
     Remote Peer(s):     172.16.113.1(*)
     Remote Site:        Default-Site
 
  Probe Timeout:         2 seconds
  Probe Threshold:       2
 
*The IP address represents the local gateway probed because the corresponding site does not have any configured peers.
Product
SteelHead CX, SteelHead EX, SteelHead-v, SteelHead-c, Interceptor
Related Commands
path-selection channel