show interfaces
Displays the running state settings and statistics.
Syntax
show interfaces {<interface-name> <cr> | [arp | brief | configured | dhcp-lease] | [brief | configured | mtu-override}
Parameters
<interface-name> <cr> | [arp | brief | configured } dhcp-lease] | Interface name. For example, aux, lan0_0, wan0_0, primary, in‑path0_0, lo. • arp - Display static and dynamic ARP entries for this interface. • brief - Displays brief running state for this interface, including the power level if you have an optical card interface installed. • configured - Displays configuration for this interface. • dhcp-lease - Displays DHCP lease for this interface. |
brief | Displays the running state settings without statistics. |
configured | Displays configured settings for the interface. |
mtu-override | Displays MTU sync override setting. |
Usage
The settings and statistics displayed vary when using DHCP.
If you are an admin user and you have an optical interface card (NIC-1-010G-2SR-BP (#410-00302-03) or NIC-1-010G-2LR-BP (#410-00301-03)) installed on the appliance, power level readings are displayed with the show interface <interface-name> brief command. For example:
amnesiac # show interface wan4_0 brief
Interface wan4_0 state
Up: yes
Interface type: ethernet
Speed: 10000Mb/s
Duplex: full
MTU: 1500
HW address: 00:0E:B6:AA:72:F0
Link: yes
Counters cleared date: 2019/12/16 00:44:33
dev 0 port 1: TX output power=522 uW or -2.823295 dBm
dev 0 port 1: RX input power=447 uW or -3.496925 dBm
Example
amnesiac # show interfaces configured
Interface aux configuration
Enabled: yes
DHCP: no
Speed: auto
Duplex: auto
IP address: 10.0.190.139
Netmask: 255.255.0.0
MTU: 1500
Interface inpath0_0 configuration
Enabled: yes
DHCP: no
IP address: 10.11.192.139
Netmask: 255.255.0.0
MTU: 1500
Failure mode: Bypass <<fail-to-block or fail-to-bypass>>
.
.
.
Product
SCC, Interceptor, SteelHead CX, SteelHead-v, SteelHead-c, Client Accelerator
Related Commands