failover steelhead addr
Sets the IP address for a failover SteelHead. A failover SteelHead is a backup appliance. If the master fails, the failover appliance takes over.
Syntax
[no] failover steelhead addr <ip-address>
Parameters
<ip-address> | IP address for the failover, backup machine. The default value is 0.0.0.0. For IPv4 addresses, use this format: XXX.XXX.XXX.XXX/XX For IPv6 addresses, use this format: X:X:X::X/XXX If you have installed multiple bypass cards, you must specify the IP address for the inpath0_0 slot. |
Usage
The no command option resets the failover IP address to the default value.
You can enter either IPv4 or IPv6 addresses. However, if you have enabled IPv6 connection forwarding, you must enter an IPv6 address. For more information about enabling IPv6 connection forwarding, see the SteelHead User Guide or the SteelHead Interceptor User Guide.
Example
amnesiac (config) # failover steelhead addr 10.10.10.1
Product
SteelHead CX, SteelHead-v, SteelHead-c, Interceptor
Related Commands