About data store settings
Data store settings are under Optimization > Data Replication: Data Store.
Data store settings
You must clear the data store for any changes to these settings to take effect.
Clearing the data store is irreversible—the stored data cannot be recovered. After clearing, restarting the service, or rebooting the appliance, all data transfers will start cold. Performance will gradually improve as the system builds up warm data references over time.
Data store encryption type
Sets the AES encryption strength for the data store. Choosing "None" disables encryption. To apply any changes—whether enabling, changing, or disabling encryption—you must clear the data store and restart the optimization service.
Enable automated data store synchronization
Enables automatic synchronization between two appliances. Designate one appliance as the primary and the other as the backup. The backup’s data store will be overwritten by the primary’s. Ensure both appliances are network-connected, and configure synchronization from the Management Console of the primary appliance.
Current appliance
Specifies whether the appliance is primary or backup.
Peer IP address
Specifies the IP address of the peer appliance. You can use either the primary interface address or the auxiliary interface address if the peer is configured to use it instead of the primary.
Synchronization port
Specifies the destination TCP port number used when establishing a connection to synchronize data. The default value is 7744.
Reconnection interval
Specifies the number of seconds to wait for reconnection attempts. The default value is 30.
Enable branch warming for clients
Enables branch warming.
Enable data store wrap notifications
Enables wrap notifications.